NEWS CENTER
Your location:
Home
>
>
>
What are the details that need to be paid attention to when using a high-speed mixer?

What are the details that need to be paid attention to when using a high-speed mixer?

(Summary description)The high-speed mixer needs to place the machine on a relatively flat table, and use square wooden blocks to pad the front and rear axles to keep the tires in an overhead state. The purpose of this is to prevent the high-speed mixer from moving when it is started. phenomenon. More details about the need to pay attention to when using the high-speed mixer will continue to be organized for everyone:

What are the details that need to be paid attention to when using a high-speed mixer?

(Summary description)The high-speed mixer needs to place the machine on a relatively flat table, and use square wooden blocks to pad the front and rear axles to keep the tires in an overhead state. The purpose of this is to prevent the high-speed mixer from moving when it is started. phenomenon. More details about the need to pay attention to when using the high-speed mixer will continue to be organized for everyone:

Information

The high-speed mixer needs to place the machine on a relatively flat table, and use square wooden blocks to pad the front and rear axles to keep the tires in an overhead state. The purpose of this is to prevent the high-speed mixer from moving when it is started. phenomenon. More details about the need to pay attention to when using the high-speed mixer will continue to be organized for everyone:

Under normal circumstances, the mixer needs to implement secondary leakage protection. After the power is turned on, you need to perform an empty test run carefully. After confirming that there is no problem, you can use it. When the high-speed mixer is working, observe the operation of the mixer drum. Is the speed in a normal state? Generally speaking, the speed of empty car running is about 2 to 3 laps faster than the speed of running after loading. If the number of turns differs a lot, the ratio between the driving wheel and the driving wheel needs to be adjusted. Then confirm whether the rotation direction of the mixing drum is the same as the direction indicated by the arrow. If it is not the same, you need to immediately change the wiring of the motor to make their directions consistent. Check the sensitivity of the clutch and brake in use, confirm whether there are signs of damage to the wire rope, whether the pulleys of the track are intact, whether there are obstacles around the high-speed mixer, and whether the lubrication of each component is sufficient, etc. . After each operation is completed or when it is not needed to use, the sliding gate must be cut off and the switch box must be locked.

The details that need to be paid attention to when using the high-speed mixer are mainly these. Everyone must operate correctly according to the instructions. Only in this way can the performance of the high-speed mixer be fully displayed. More information about the high-speed mixer will continue to be organized for everyone. I hope it can be helpful to everyone's operation.

Keyword:

Scan the QR code to read on your phone

Relevant Information

Copyright © 2021 Zhengzhou Topleap Food Machinery Co., Ltd.

This website already supports IPv6

Online message
code